载铜树脂处理高含盐氨氮废水的性能

针对高含盐氨氮废水，选择具有不同功能基团的树脂为载体，进行负载Cu2+改性制得载铜树脂并对其处理高含盐氨氮废水的性能进行研究。在筛选出最佳载铜树脂的基础上，研究pH及Na+浓度、树脂投加量、反应时间对载铜树脂处理高含盐氨氮废水效果的影响，通过对吸附氨氮前后的载铜树脂进行SEM和EDS表征分析并构建吸附动力学模型以进一步探究配位吸附的过程。结果表明，Cu2+可与螯合树脂D751稳定结合且在宽pH值下均表现出耐盐性和良好的氨氮吸附效果；在室温(25℃)、pH=11及Na+浓度4 g/L、树脂投加量8 g/L、反应时间60 min的条件下，D751载铜树脂对氨氮的去除率为34.8%。D751载铜树脂吸附氨氮后其表面出现明显的晶状结构物质，该物质可能为铜氨络合物。D751载铜树脂对高含盐氨氮的吸附符合准二级动力学模型。     

基于α-FeOOH催化H2O2蒸气的低温烟气脱硝实验

针铁矿是分布广泛、储量丰富的铁氧化物，其主要成分为α-羟基氧化铁（α-FeOOH）。为了探究针铁矿在催化H₂O₂烟气脱硝反应中的性能，本文通过沉淀-水解法制备了α-FeOOH，并在自行搭建的实验台上开展了α-FeOOH催化H₂O₂的低温烟气脱硝实验研究，深入分析了H₂O₂流量、H₂O₂浓度、汽化温度、反应温度和共存气体浓度等工况参数对脱硝性能的影响。采用离子色谱（IC）分析了单独脱硝反应和同时脱硫脱硝反应后的含氧酸成分，结合各项表征分析技术考察了催化剂反应前后的理化特性和稳定性。实验结果显示，随着汽化温度和反应温度的升高，NO的脱除效率先增加后降低；增加H₂O₂浓度对脱硝效率有明显的促进作用。当汽化温度为140℃、反应温度为160℃时，以2.5mL/h注入10mol/L的H₂O₂脱硝效率达到80%。当SO₂浓度为1000μL/L时，脱硝效率提高至86.4%。离子色谱分析结果显示，单独脱硝反应和同时脱硫脱硝反应后含氧酸产物为HNO₃和H₂SO₄。反应前后催化剂的表征结果显示，α-FeOOH在脱硝反应后依然具有良好的稳定性，显示出针铁矿在低温烟气脱硝工艺中的潜在应用前景。     

Effect of clad ratio on interfacial microstructure and properties of cladding billets via direct-chill casting process

Numerical simulation and experiments were introduced to develop AA4045/AA3003 cladding billets with different clad-ratios. The temperature fields, microstructures and mechanical properties near interface were investigated in detail. The results show that cladding billets with different clad-ratios were fabricated successfully. Si and Mn elements diffused across the bonding interface and formed diffusion layer. With the increase of clad-layer thickness, the interfacial region transforms from semisolid–solid state to liquid–solid state and the diffusion layer increased from 10 to 25 μm. The hardness at interface is higher than that of AA3003 side but lower than that of the other side. The bonding strength increased with the clad-layer thickness, attributing to solution strengthening due to elements diffusion. The cladding billets were extruded into clad pipe by indirect extrusion process after homogenization. The clad pipe remained the interfacial characteristics of as-cast cladding billet and the heredity of clad-ratio during deformation was testified.     

Methodology for optimization of pouring variables using bottom pour for low masses of SS304 (<300 kg) in investment casting process (case study)

Bottom pour ladles with stopper rod systems are commonly used in the metal casting industry. However, stopper rod bottom-pouring systems have not yet been developed for the lower thermal masses of alloys typically used in the investment casting industry. Large thermal masses used with bottom pour systems are typically limited for ladles larger than 700 kg and to certain alloys with higher fluidity and longer solidification time like cast iron, aluminum alloys etc. In this study, bottom pour ladle designs and low thermal mass refractory systems have been developed and evaluated in production investment foundry trials with 300 kg pouring ladle. The ladles system and pouring practices used will be described along with the results from the pouring trials for SS304 that represents typical alloys used in Investment casting industries. Optimization of the variables used in an experimentation using Genetic algorithm is also explained.     

LTE室分高倒流小区解决方案的研究

LTE室分高倒流直接影响室内4G用户的感知，同时较大程度拉低LTE网络驻留率指标。由于室内无线环境的封闭性，室分小区之间的覆盖独立性，仅仅通过参数调整的手段达到降低高倒流的效果非常不明显，因此本文针对目前影响室内用户感知的高倒流问题，从高倒流小区的标准出发，对室分高倒流小区的发现手段，产生原因及解决方案进行详尽地阐述，并针对各类型的高倒流情形提出解决方法，最终提供读者发现、分析及解决室分高倒流小区的有效方案，从而作为研究方法提供给LTE室内小区高倒流问题解决的指导意见     

Changes of the cell surface hydrophobicity of Lactobacillus acidophilus La‐5 in response to pH,temperature and inulin

The main topic of this study was to study how cell surface hydrophobicity (CSH) could change in response to pH, temperature and inulin; Lactobacillus acidophilus La‐5 was used as a model microorganism. pH, temperature, inulin and incubation time (exposure to prebiotic or incubation at pH 4.0 and 9.0) were combined through a full factorial design and a Central Composite Design; the results were analysed using a multifactorial anova (first step) and a stepwise regression (second step). Temperature and pH significantly affected CSH: an increase in the temperature determined a significant increase in CSH, whereas the correlation pH vs. CSH was negative, as an increase in pH caused a significant decrease in CSH. Inulin played a significant role, but its effect could be influenced by temperature, pH and exposure time. This study is the first approach on the effects of some environmental factors on CSH and suggests that the culturing conditions and/or the exposure to some prebiotics could modify it with positive or negative effects.     

极端耗水层带精准识别和调堵新技术

油田注水开发后期,部分油层存在极端耗水层带,存在耗水量大,注水驱油效率低,水循环成本高的开发问题,精准认识并有效封堵极端耗水层带,可提高注水利用率。目前国外出现了应用磁性纳米粒子的精细表征新技术及超顺磁性纳米颗粒封堵新技术,抑制极端耗水,实现低成本、高强度、深度堵调。     

浅谈煤与瓦斯突出矿井"U"型通风系统采煤工作面上隅角瓦斯管理

屯兰煤矿是煤与瓦斯突出矿井,瓦斯涌出量大,上隅角瓦斯治理困难。为解决这一通风难题,该矿采取沿空留巷抽采措施进行作业。实践证明,该技术解决了上隅角瓦斯积聚隐患,保障了矿井高产高效。